Cmod A7: Breadboardable Artix-7 (15T) - EOL

The Digilent Cmod A7 is a small, breadboard friendly 48-pin DIP form factor board built around a Xilinx Artix-7 FPGA. The board also includes a USB-JTAG programming circuit, USB-UART bridge, clock source, Pmod host connector, SRAM, Quad-SPI Flash, and basic I/O devices. These components make it a formidable, albeit compact, platform for digital logic circuits and MicroBlaze embedded soft-core processor designs using Xilinx's development software, Vivado.

There are 44 Digital FPGA I/O signals and two FPGA Analog inputs that are routed to 100-mil-spaced through-hole pins so that you can integrate your programmable logic design directly into a solderless breadboard circuit. At just 0.7” by 2.75”, it can also be loaded in a standard socket and used in embedded systems.

Note:
The only difference between the Cmod A7-15T and Cmod A7-35T are the capabilities of the FPGA found on the board. They compare as follows:

Features

• System Features
  - 512KB SRAM with an 8-bit bus and 8ns access times
  - 4MB Quad-SPI Flash
  - USB-JTAG Programming Circuitry
  - Powered from USB or external 3.3-5.5V supply connected to DIP pins
• System Connectivity
  - USB-UART bridge
• Interaction and Sensory Devices
  - 2 LEDs
  - 1 RGB LED
  - 2 Push Buttons
• Expansion Connectors
  - 48-pin DIP connector with 44 Digital I/O and 2 Analog inputs (0-3.3V)
  - One Pmod connector with 8 Digital I/O

Scope of Delivery

• 1 x Cmod A7 Artix-7 (15T) FPGA Module

References

• Manufacturer: Digilent Inc.
• Manufacturer's article name: Cmod A7: Breadboardable Artix-7 FPGA Module
• Manufacturer's article number: 410-328

Resources

• Product Page at Digilent Inc.
• Digilent Inc. Support Forum