JTAG USB Cable

The JTAG-USB cable allows you to use your PC to connect to a JTAG scan chain or to access an SPI interface on a board equipped with the appropriate 6-pin header. In this way, you can program devices on Digilent programmable logic boards using the Digilent Adept Suite. You can also program AVR micrcontrollers on Digilent embedded control boards using the Digilent AVR programmer application.

To download the newest versions of the afore-mentioned software, please visit the following pages:

• Digilent Adept suite
• Digilent AVR Device Programmer

Need help choosing a board? Let us help you with a Programming Solutions Comparison table!

Stats

Connector(s): USB type A to 6-pin female header connector

Programming: FPGA Programming accomplished via the Digilent Adept Suite Software

Features

• Low-cost JTAG configuration solution
• Connects to the USB port of a PC, and to a standard 6-pin JTAG programming header
• Can be used with Digilent Adept Suite & AVR Device Programmer software
• Can program devices that have a JTAG voltage of 1.8V or greater

Scope of Delivery

• 1 x JTAG USB Cable

References

• Manufacturer: Digilent Inc.
• Manufacturer's article name: JTAG-USB Programming Cable, JTAG USB Cable
• Manufacturer's article number: JTAG-USB, 250-003

Resources

• Product Page at Digilent Inc.
• Manufacturer programming solutions comparison table
• Software: Digilent Adept suite
  - Digilent AVR Device Programmer
• Digilent Inc. Support Forum